Compensation benchmarking for PLC Panel Builders: pay for wiring and site skill
A panel builder pays for two very different skills: neat wiring at the bench and fault finding on site. Benchmarking shows whether your pay reflects that difference.
Not sure what you need? Tell us about your business in six short steps and we will come to the first meeting prepared.
Share your requirementsWhy compensation benchmarking matters in PLC panel builders
Some panel shops set pay by who asked last. A wiring technician who leaves clean looms and few test faults earns the same as one who needs rework, and a programmer who is poached gets a counter offer that upsets everyone else. Site engineers on long trips see bench staff earning close to them and wonder why they travel.
Good practice is a simple band for each role, checked against what similar shops in your city pay, with clear steps for a technician who can read drawings alone, test a panel and train a helper. The band is written down, so a raise is a decision rather than a negotiation in the corridor.
How to set it up
1. List the roles and levels
Write down helper, wiring technician, senior technician, tester, designer, programmer and commissioning engineer. Mark who can work alone on a drawing and who needs checking. Levels come from skill, not years.
2. Collect what you pay today
Gather basic pay, overtime habits, travel allowance and site food or stay support for each person. Keep it in one sheet by role. The gaps between people doing the same work become visible at once.
3. Check against the market
Ask three or four peer shops, a few recruiters and your own recent offer rejections what each role costs now. We would look at how to read this honestly. for how we frame it.
4. Set bands and a skill ladder
Give each role a low, middle and high figure. Tie a step up to clear skills, such as wiring a full panel to drawing without rework or commissioning a drive alone.
5. Plan a travel and site allowance
Decide a fixed rule for site days, overnight stay and weekend work, so engineers are not bargaining each trip. Review it once a year, not per job.
Check these first
Before changing anything, find out what is true today. Use your own records for a defined period and note gaps in the evidence. The review may take longer if records are incomplete or spread across teams.
- Pay of your last five resignations against the band you would set today
- Pay gap between your best and weakest wiring technician on the same grade
- Number of offers declined in the last year and the figure asked
- Site allowance paid per trip, listed side by side for each engineer
GullyHR can do this with you. Read how we approach compensation benchmarking in general, or share your requirements and we will tell you where to start.
Questions owners ask
Once a year is enough for most panel shops, with a quick look when someone resigns or an offer is refused. Between checks, keep your band sheet current so you know who is above or below it.
Yes, if the skill gap is real. A technician who wires to drawing with few faults saves testing time and customer complaints. A visible ladder from helper to technician also keeps helpers from leaving to learn elsewhere.
Not always. Smaller shops compete on faster responsibility, steadier hours and a fair ladder. Benchmarking shows where you can stay close and where a gap is too wide to ignore.
We set up the interview and hiring process for PLC panel builders
Every business interviews, but few have a written process that works the same way for every role and every interviewer. GullyHR designs yours, from the role brief to the offer, trains your managers to run it, and can run it for you on the roles you hand us.